Search found 7 matches

by TTx380
2021-01-23 10:31
Community: Tips, Tricks and Tech Help
Topic: Anet A8 y axis overheat
Replies: 6
Views: 2313

Re: Anet A8 y axis overheat

Sorry for the late reply, hasn't been in the forum for a long time. There is a small potentiometer on the stepper driver, the screw in the middle is the + pole. The housing of the card reader is the - pole. To measure, you need a multimeter and fine measuring tips. The Vref is then adjusted with the...
by TTx380
2021-01-23 10:24
Community: Tips, Tricks and Tech Help
Topic: ET4 - After few layers, temp head switch off
Replies: 1
Views: 1018

Re: ET4 - After few layers, temp head switch off

Check the Tempsensor incl. Harness
Temp Failures are most a Sensor trouble.
by TTx380
2021-01-23 10:22
Community: Open Source
Topic: Anet A8 Plus Y- axis motor
Replies: 1
Views: 726

Re: Anet A8 Plus Y- axis motor

Prüf mal, ob die Y-Achse beim manuellen verfahren über das Menü in die richtige Richtung fährt. Wenn nicht, muß die Motordrehrichtung geändert werden (https://drucktipps3d.de/quickie-motorrichtung-aendern/). Ansonsten mal den Endschalter überprüfen, inkl. Verkabelung.
by TTx380
2020-11-24 12:32
Community: Tips, Tricks and Tech Help
Topic: Anet A8 y axis overheat
Replies: 6
Views: 2313

Re: Anet A8 y axis overheat

Is the carriage of the Y-Axis free moveable?
Check the Vref from the Stepperdriver, it should be nearly the same as on the Driver from the x-Axis
by TTx380
2020-11-23 8:35
Community: Anet 3D Printers
Topic: ET4 temperature sensor issues ?
Replies: 4
Views: 880

Re: ET4 temperature sensor issues ?

What Temperature is indicated on the Screen, actual and preselected?
by TTx380
2020-11-17 16:32
Community: Tips, Tricks and Tech Help
Topic: ET4 Pro and Pronterface Trbl.
Replies: 1
Views: 577

ET4 Pro and Pronterface Trbl.

Hello, My ET4 Pro has problems with Pronterface. The X-axis works normally. Heating from the hotend and heating bed also works. When controlling the Y and Z axes, Pronterface crashes, the error message is: "[ERROR] Can't write to printer (disconnected?) (SerialException): Write timeout". Then I have...
by TTx380
2020-11-17 16:15
Community: Anet 3D Printers
Topic: Blocked screen ET4X
Replies: 1
Views: 510

Re: Blocked screen ET4X

If the memory card is inserted, remove it, and try again