Anet et4 not printing with cura

For all who are new to 3D Printing, Rapid Prototyping and Additive Fabrication in general
Community rules
1. Be kind and courteous
We're all in this together to create a welcoming environment. Let's treat everyone with respect. Healthy debates are natural, but kindness is required.

2. No hate speech or bullying
Make sure everyone feels safe. Bullying of any kind isn't allowed, and degrading comments about things such as race, religion, culture, sexual orientation, gender or identity will not be tolerated.

3. Only 3D printers advertised.
Only 3D printers or directly related product may be advertised. If you post anything else it will be moderated and you will be banned.

4. Replying to posts
If you reply to a post, make sure your reply is connected with the main topic, do NOT take a topic off track.

5. All post are moderated
Every post on here is moderated - always. Don't bother joining unless you have works to share or problems to inquiry about 3D printers. That is all that will be allowed on this group.
Post Reply
User avatar
Cdavami
Posts: 3
Joined: 2020-11-22 22:03

Seems like no matter what I try to print whether an calibration cube or the provided fan duct. All I get is a single little blob of pla about 5 mm wide. I don’t understand what is going on. Also when I hit print, the nozzle and bed stay at zero unless I preheat it. Maybe these problems are connected I am not sure


Post Reply