Anet et4+ where is my z endstop switch?

Anet 3D printers, add-ons and OEM
Community rules
1. Be kind and courteous
We're all in this together to create a welcoming environment. Let's treat everyone with respect. Healthy debates are natural, but kindness is required.

2. No hate speech or bullying
Make sure everyone feels safe. Bullying of any kind isn't allowed, and degrading comments about things such as race, religion, culture, sexual orientation, gender or identity will not be tolerated.

3. Only 3D printers advertised.
Only 3D printers or directly related product may be advertised. If you post anything else it will be moderated and you will be banned.

4. Replying to posts
If you reply to a post, make sure your reply is connected with the main topic, do NOT take a topic off track.

5. All post are moderated
Every post on here is moderated - always. Don't bother joining unless you have works to share or problems to inquiry about 3D printers. That is all that will be allowed on this group.
Post Reply
User avatar
Edelmann82
Posts: 2
Joined: 2021-01-23 8:26

i have buy this anet et4+ with firmware vedrsion 1.0!

i try to level it but every time it crashes into the bed when i press home in settings or level menu.

now my printer has no z endstop so he cant know when he must stop or is the leveleling sensor the z endswitch on this printer if it is so the sensor is faulty.

any tips or ideas for me?

regards

E82


User avatar
blacklisted
Posts: 1
Joined: 2021-01-25 15:14

shut off your printer go to setting sat z to 2mm to your bed adjust the leveling sensor is red set it 2 additional points make sure going down 2 or three the light goes on then up to off the auto home then manual level
User avatar
Edelmann82
Posts: 2
Joined: 2021-01-23 8:26

not working still the same problem
Post Reply