Anet E4X with Level Sensor

Anet 3D printers, add-ons and OEM
Community rules
1. Be kind and courteous
We're all in this together to create a welcoming environment. Let's treat everyone with respect. Healthy debates are natural, but kindness is required.

2. No hate speech or bullying
Make sure everyone feels safe. Bullying of any kind isn't allowed, and degrading comments about things such as race, religion, culture, sexual orientation, gender or identity will not be tolerated.

3. Only 3D printers advertised.
Only 3D printers or directly related product may be advertised. If you post anything else it will be moderated and you will be banned.

4. Replying to posts
If you reply to a post, make sure your reply is connected with the main topic, do NOT take a topic off track.

5. All post are moderated
Every post on here is moderated - always. Don't bother joining unless you have works to share or problems to inquiry about 3D printers. That is all that will be allowed on this group.
Post Reply
User avatar
Rex3900
Posts: 2
Joined: 2020-09-17 18:24

Hope someone can help. I have purchased the E4X and would like to add the Auto Bed Level Sensor.
Can this be done and is there an Update for the Firmware.
Also I have a Creality Ender 3 and since getting the ANET I consider it to be far superior in Build and overall quality.
ANET E4X is now my No 1 Printer.


User avatar
AnetLau
Posts: 813
Joined: 2020-06-24 1:56

Hello, I do not recommend you to modify your ET4X, you can buy a ET4 that has an auto level sensor.
User avatar
Bioschock
Posts: 1
Joined: 2020-09-15 11:57

you can install a auto level sensor in marlin you can mod this with vscode use the marlin guide i have replace my printer anet et4 TMC 4998 to et4 pro printer board with tmc2208 driver on it importent is to seht the driver you have say marlin what driver you will be able to install. make a backup if give isue. if you will use BL touch so you will use the z plug pins musst find in the document from anet dont forget to set z max to z min and make an offset of BL touch if you dont you crash the nozzle in the bed and your BL Touch will brake
User avatar
Rex3900
Posts: 2
Joined: 2020-09-17 18:24

I know I can buy a Anet E4 but I enjoy playing with the printers so all I am asking is if I put the Sensor on my printer do I update to V1.1.5 or go straight to Marlinand setup there.
Someone else must have done this in the past.
Post Reply