ET4 temperature sensor issues ?

Anet 3D printers, add-ons and OEM
Community rules
1. Be kind and courteous
We're all in this together to create a welcoming environment. Let's treat everyone with respect. Healthy debates are natural, but kindness is required.

2. No hate speech or bullying
Make sure everyone feels safe. Bullying of any kind isn't allowed, and degrading comments about things such as race, religion, culture, sexual orientation, gender or identity will not be tolerated.

3. Only 3D printers advertised.
Only 3D printers or directly related product may be advertised. If you post anything else it will be moderated and you will be banned.

4. Replying to posts
If you reply to a post, make sure your reply is connected with the main topic, do NOT take a topic off track.

5. All post are moderated
Every post on here is moderated - always. Don't bother joining unless you have works to share or problems to inquiry about 3D printers. That is all that will be allowed on this group.
Post Reply
User avatar
Cdavami
Posts: 3
Joined: 2020-11-22 22:03

Hello,
I just got an ante et4 and the temperature for the extruded is not reading properly and not heating up. I am running V 1.1.t firmware and I can’t seem to identify the problem. Could somebody help me trouble shoot?


User avatar
TTx380
Posts: 4
Joined: 2020-11-17 16:13

What Temperature is indicated on the Screen, actual and preselected?
User avatar
Cdavami
Posts: 3
Joined: 2020-11-22 22:03

It goes back and forth between 24 and 25 /0 C and when I try to heat up it is 24/ 220. Eventually it will glitch and go back to 24/0 C and then will not let me change until I power off the machine. I have a brand new thermistor so that is not the problem.

And I am on version 1.1.5 as well.
Last edited by Cdavami on 2020-11-24 23:30, edited 3 times in total.
User avatar
Indy_UKCM
Posts: 2
Joined: 2020-11-25 17:37

I am having similar issues with the ET5X

Printing set at 210 but variance on screen is from 201 - 221
User avatar
piledrive01+
Posts: 3
Joined: 2020-09-17 9:49

Check the "END" connection of the sub board mounted to the carriage. The problem and two solutions are there.
Post Reply