Page 1 of 1

ET4 M503

Posted: 2020-12-26 11:57
by jlb0305
I have firmware 1.1.7 on my ET4 and I'm trying to run code M503 but nothing happens. I followed the directions found here <https://shop.anet3d.com/blogs/download/show-gcode-m503>. I have tried getting the values from Pronterface and via OctoPi but it doesn't do anything. No response on Pronterface and simply "Ok" on octopi. Any idea whats wrong? trying to tweak steps based on cal cube and benchy results.