BLtouch on ET4X possible??
Posted: 2021-01-04 19:00
Is it possible to install a BLtouch sensor on the ET4X?
As i understand it, the only difference betweent he ET4, and the ET4X is the location of the z limit switch, and the auto leveling sensor.
Is there firmware available to enable the sensor, or is there a how-to guide for building marlin for this printer so i can enable the sensor?
Also, why did my last question get deleted?
As i understand it, the only difference betweent he ET4, and the ET4X is the location of the z limit switch, and the auto leveling sensor.
Is there firmware available to enable the sensor, or is there a how-to guide for building marlin for this printer so i can enable the sensor?
Also, why did my last question get deleted?