Anet A2 Plus

Anet 3D printers, add-ons and OEM
Community rules
1. Be kind and courteous
We're all in this together to create a welcoming environment. Let's treat everyone with respect. Healthy debates are natural, but kindness is required.

2. No hate speech or bullying
Make sure everyone feels safe. Bullying of any kind isn't allowed, and degrading comments about things such as race, religion, culture, sexual orientation, gender or identity will not be tolerated.

3. Only 3D printers advertised.
Only 3D printers or directly related product may be advertised. If you post anything else it will be moderated and you will be banned.

4. Replying to posts
If you reply to a post, make sure your reply is connected with the main topic, do NOT take a topic off track.

5. All post are moderated
Every post on here is moderated - always. Don't bother joining unless you have works to share or problems to inquiry about 3D printers. That is all that will be allowed on this group.
Post Reply
User avatar
Jaycen
Posts: 1
Joined: 2021-01-10 9:36

Hello! I just joined the community today.

I purchased an A2 Plus three years ago. I'm running into issues now that I'm finally ready to do some more advanced things.

I noticed that the printer doesn't know it's a "plus" model. Even though I have Cura setup to print 220 x 270, the printer itself will not print past 220 in the Y axis. I tried flashing firmware, but I think I have to flash the boot code, because it didn't make a difference.

I'm also struggling with the cooling fan. The output is at 100% all the time, and it doesn't matter what I set in the slicer.

I love this little printer. It has taken me this long to become proficient enough before doing more advanced things, but now that I'm here it's really hard to find information on the A2. I would appreciate any direction any can give me.

Thanks!


Post Reply