Anet ET4Pro homing/leveling problem

Tips & Tricks to tweak your printers, as well as technical help. Topics MUST contain the type of printer you are addressing!
Community rules
1. Be kind and courteous
We're all in this together to create a welcoming environment. Let's treat everyone with respect. Healthy debates are natural, but kindness is required.

2. No hate speech or bullying
Make sure everyone feels safe. Bullying of any kind isn't allowed, and degrading comments about things such as race, religion, culture, sexual orientation, gender or identity will not be tolerated.

3. Only 3D printers advertised.
Only 3D printers or directly related product may be advertised. If you post anything else it will be moderated and you will be banned.

4. Replying to posts
If you reply to a post, make sure your reply is connected with the main topic, do NOT take a topic off track.

5. All post are moderated
Every post on here is moderated - always. Don't bother joining unless you have works to share or problems to inquiry about 3D printers. That is all that will be allowed on this group.
Post Reply
zaven_azatyan
Posts: 1
Joined: 2020-08-30 20:07

Hi All.
Please help me with Anet ET4 Pro homing/leveling.
The head and the bed stays at position 0, instead of moving to (135,106) position.
I have assembled the printer and when tried to make the leveling I faced this situation.



The firmware is stock: 1.0.2


Zero4Zero
Posts: 7
Joined: 2020-09-06 11:44

Do not touch the sensor, then it also drives into home, if they touch the sensor it can happen that it stops because it means home for the printer then
Hitherto
Posts: 1
Joined: 2020-09-01 1:58

I have the same problem, i message with Anet support team and they send me a new motherboard.
Justgoogleit
Posts: 2
Joined: 2020-09-02 20:23

Zero4Zero wrote: 2020-09-06 12:22 Do not touch the sensor, then it also drives into home, if they touch the sensor it can happen that it stops because it means home for the printer then
I guess it is not the sensor problem, it is the obviously that program have some problem.
Post Reply