Page 2 of 2

Re: Anet ET4+ dont want to print

Posted: 2020-09-12 0:07
by ricalbertvig
I am using translator ... I mean that with a memory of 2 gb I have the same problem-- the printer starts counting from 1% to 100% without doing its job..a piece of 10 hours prints it in less than 1 minutes and the green sign comes out of ok the printing to finishe

Re: Anet ET4+ dont want to print

Posted: 2020-09-12 1:32
by AnetLau
ricalbertvig wrote: 2020-09-12 0:07 I am using translator ... I mean that with a memory of 2 gb I have the same problem-- the printer starts counting from 1% to 100% without doing its job..a piece of 10 hours prints it in less than 1 minutes and the green sign comes out of ok the printing to finishe
Hello friend, could you send your issue to our support team by support@anet3d.com. Tell them you have format the SD card but no any effect. They will give you some guidance. It is better for take some video for them. Thanks.

Re: Anet ET4+ dont want to print

Posted: 2020-09-12 20:26
by ricalbertvig
Greetings, I tell you that the memory brand is important, now format a memory of 2 GB of a good brand and it is working well, format in slow format ... thanks for the guidance

Re: Anet ET4+ dont want to print

Posted: 2020-09-13 7:17
by Zero4Zero
Testprint 1


Testprint 2


Testprint 3

After I applied a bit of a printing bed adhesion, the template also remained sticky and he prints until the end.

What is the difference to my sliced data ?

Re: Anet ET4+ dont want to print

Posted: 2020-09-13 8:14
by Zero4Zero


And here is the endresult of the testprint :(