ET4 + Motherboard on ET4

3D printer products mods, upgrades and product designs
Community rules
1. Be kind and courteous
We're all in this together to create a welcoming environment. Let's treat everyone with respect. Healthy debates are natural, but kindness is required.

2. No hate speech or bullying
Make sure everyone feels safe. Bullying of any kind isn't allowed, and degrading comments about things such as race, religion, culture, sexual orientation, gender or identity will not be tolerated.

3. Only 3D printers advertised.
Only 3D printers or directly related product may be advertised. If you post anything else it will be moderated and you will be banned.

4. Replying to posts
If you reply to a post, make sure your reply is connected with the main topic, do NOT take a topic off track.

5. All post are moderated
Every post on here is moderated - always. Don't bother joining unless you have works to share or problems to inquiry about 3D printers. That is all that will be allowed on this group.
Post Reply
User avatar
leoboasorte
Posts: 1
Joined: 2020-11-17 14:53

Hello guys!

There was a power incident at my house, and I had to change the motherboard for my ANET ET4. So, I purchased the new card, specifying that I wanted the ET4 and not the ET4 + or PRO, only that the seller sent me wrong, arriving the card with ET + 1.0.0 Firmware.

So, I wanted help from you, because I can't put the Firmware of ANET ET4 1.1.5 via SD card, with Update Fail error.

What do you recommend me? The printer even turned on, and I loved the silence on the stepper motors, I would like it to be that silent.

I saw that there is Open Firmware, installing it via ST-LINK, will it work?

ANET, can you help me?


Post Reply