How to Install J-Link-OB Driver

Talking About Open Source Of Anet 3D Printer
Post Reply
User avatar
AnetLau
Posts: 816
Joined: 2020-06-24 1:56

This document introduces how to install needed driver for the J-Link-OB to your PC.

Requirements:


PC: Windows 7 (64 bit)

Software: Setup_JLinkARM_V468.exe

Hardware Debug Downloader: J-Link-OB



Installation Procedures:



Double click on ”exe ”


Image



Click on “yes” to agree conditions


Image



Click on “Next” to go on.


Image



Select destination folder for installation.


Image



Check the option “Install USB Driver for J-Link-OB with CDC”. And if wanted, you can also check the option “Add shortcuts to desktop”. Then click on “Next>” to go on.


Image



Click on “Next>” to proceed to installation.


Image



Installation automatically goes on and detailed information will display step by step.


Image



Follow prompt messages to ensure all renewals of required programing software (such as ARM, MDK, IAR...) are checked and click on “OK” to proceed.


Image



Click on “Finish” to complete installation and exit.


Image



Two icons stand for J-Link and J-Flash will appear on the desktop of your computer (if you select desktop shortcut at step 5 for installation).


Image



It means that J-Link ARM and J-Flash Arm are successfully installed.


10. Connect J-Link-OB to the computer with a USB cable, it will remind to install a driver. And the driver can be seen in device manager section after being successfully installed


Image



PS:
J-Link is available in our store, just go to the homepage and search for it.


Post Reply