LOAD FILAMENT - No load filament with Marlin 2.0.7.2

Talking About Open Source Of Anet 3D Printer
Post Reply
User avatar
yosmanor
Posts: 1
Joined: 2020-12-06 7:38

Hello there, help needed
I am New to 3D printing.
I have an Anet A8 Plus printer. I flashed Marlin 2.0.7.2 firmware for enhancement.
I followed the instructions below to enable "Load Filament."
I Used Visual Studio to upload the changes.
Process was successful, No error or warning .After loading it to the motherboard, no errors appear and a success prompt is displayed.
Upon restarting the printer, I refreshed the EEPROM.
I expected to see load filament as a option on the LCD, but it is not there.
Does anyone have suggestion?
Is there anything else that is needed to enable M600?, I tried it in Cura but still no load filament menu item

Thank you in advance.

Change i Marlin 2.0.7.2 to:
configuration.h 2020
configuration_adv.h 2020


Steps:
configutaion.h
NOZZLE_PARK_FEATURE - Enabled
EXTRUDE_MAXLENGTH – Set to 600

configuration_adv.h
In ADVANCED PAUSE FEATURE (enabled)
FILAMENT CHANGE SLOW LOAD FEEDRATE TO 10
FILAMENT CHANGE SLOW LOAD LENGTH to 25
FILAMENT CHANGE FAST LOAD FEEDRATE to 100
FILAMENT CHANGE FAST LOAD LENGTH to 500
ADVANCED PAUSE PURGE LENGTH – enabled
PARK HEAD ON PAUSE – enabled
Uploaded


Post Reply