Open Source Firmware of ET4

Talking About Open Source Of Anet 3D Printer
Post Reply
User avatar
AnetLau
Posts: 815
Joined: 2020-06-24 1:56

Download open-source firmware of ET4.
Hidden Content
This board requires you to be registered and logged-in to view hidden content.

The link of Code.
Hidden Content
This board requires you to be registered and logged-in to view hidden content.

Disclaimer

This open source firmware and code are for reference and research use only, not for commercial use.

Anet is only responsible for the after-sales problems of the stable version (not open source firmware).

Such as the machine failure caused by the user's flashing (open source firmware) adjustment parameters, Anet has Right to refuse to provide after-sales service.


User avatar
fastrite
Posts: 1
Joined: 2020-08-17 3:59

Is the ET4 configuration for standard machine with A4988 drivers?
User avatar
AnetLau
Posts: 815
Joined: 2020-06-24 1:56

fastrite wrote: 2020-08-17 4:49 Is the ET4 configuration for standard machine with A4988 drivers?
Yes, it is!
User avatar
Vasek1
Posts: 3
Joined: 2020-08-17 2:07

To compiled from page link github after = 355KB
Download compiled bin 401KB
?????
User avatar
AnetLau
Posts: 815
Joined: 2020-06-24 1:56

Vasek1 wrote: 2020-08-18 9:53 To compiled from page link github after = 355KB
Download compiled bin 401KB
?????
viewtopic.php?f=58&t=887

this is the guidance of firmware, and we will make some tutorials about operating the new system.
User avatar
guardiansnet
Posts: 2
Joined: 2020-08-18 19:07

I have an ET4+, is there an update for me? Thanks!
Last edited by guardiansnet on 2020-08-18 20:10, edited 1 time in total.
User avatar
AnetLau
Posts: 815
Joined: 2020-06-24 1:56

guardiansnet wrote: 2020-08-18 19:11 I have an ET+, is there an update for me? Thanks!
The ET5 series has not yet released an open source system. We will release it soon. Please pay attention to our community notice. Thanks.
User avatar
guardiansnet
Posts: 2
Joined: 2020-08-18 19:07

That was a typo, I have an ET4+.
User avatar
AnetLau
Posts: 815
Joined: 2020-06-24 1:56

guardiansnet wrote: 2020-08-18 20:11 That was a typo, I have an ET4+.
ET4 series are suitable to use.
User avatar
zhonghua
Posts: 1
Joined: 2020-08-19 5:54

awesome
Post Reply