Page 2 of 5

Re: Open Source Firmware of ET4

Posted: 2020-08-20 0:31
by demegens
Which parameters should be calibrated and are machine specific? Like ie nozle height I think esteps and more have to be adjusted per machine. For me as beginner it would be good to know whatsoever I have to calibrate when upgrading to this new open software.

Re: Open Source Firmware of ET4

Posted: 2020-08-20 5:04
by aceamundo
is this for et4x

Re: Open Source Firmware of ET4

Posted: 2020-08-22 12:40
by ArnefSuero
I just upgraded my et4+ to the open source and the touchscreen just stoped working, i can control the printer from pronterface but i would like to know how to solve the issue with the screen

Re: Open Source Firmware of ET4

Posted: 2020-08-25 18:24
by AnetLau
demegens wrote: 2020-08-20 0:31 Which parameters should be calibrated and are machine specific? Like ie nozle height I think esteps and more have to be adjusted per machine. For me as beginner it would be good to know whatsoever I have to calibrate when upgrading to this new open software.
That is right. We are arranging to make some Tutorials about how to use ET4 Open firmware. If you have any advises, please share with us. Thanks.

Re: Open Source Firmware of ET4

Posted: 2020-08-25 18:25
by AnetLau
aceamundo wrote: 2020-08-20 5:04 is this for et4x
Yes, it is suitable for ET4 series.

Re: Open Source Firmware of ET4

Posted: 2020-08-25 18:28
by AnetLau
ArnefSuero wrote: 2020-08-22 12:40 I just upgraded my et4+ to the open source and the touchscreen just stoped working, i can control the printer from pronterface but i would like to know how to solve the issue with the screen
could you give me some detail description about you issue, it is better in video or picture.

Re: Open Source Firmware of ET4

Posted: 2020-08-27 3:13
by simonreef
what do I compile the firmware with?

Re: Open Source Firmware of ET4

Posted: 2020-08-27 4:16
by spectremz
AnetLau wrote: 2020-08-25 18:28
ArnefSuero wrote: 2020-08-22 12:40 I just upgraded my et4+ to the open source and the touchscreen just stoped working, i can control the printer from pronterface but i would like to know how to solve the issue with the screen
could you give me some detail description about you issue, it is better in video or picture.
the problem is fixable pressing the touch screen for 5 seconds and complete the calibration of the screen!

Re: Open Source Firmware of ET4

Posted: 2020-08-28 9:31
by kandissa
AnetLau wrote: 2020-08-25 18:28
ArnefSuero wrote: 2020-08-22 12:40 I just upgraded my et4+ to the open source and the touchscreen just stoped working, i can control the printer from pronterface but i would like to know how to solve the issue with the screen
could you give me some detail description about you issue, it is better in video or picture.
Facing same issue with my ET4 Pro. Flashed the file et4p_et4+.bin contained within the Firmware_ET4-Open.Source-3.zip file.


Re: Open Source Firmware of ET4

Posted: 2020-08-29 18:44
by lumina242
do i just flash the bin file or do i need something to install it