Open Source Firmware of ET4

Talking About Open Source Of Anet 3D Printer
User avatar
javier
Posts: 1
Joined: 2021-01-20 6:24

What I have to do for change the PID?


User avatar
dCrypt
Posts: 2
Joined: 2020-09-04 8:13

dCrypt wrote: 2021-01-08 7:10 Hi, @AnetLau,

Here viewtopic.php?f=58&t=886 you publish three binaries for ET4,ET4X,ET4PRO/+ corresponding to the Marlin OpenSource code. However, the configs are not published. Why you still publish "closed binaries" from alternative sources?

Unless you share the "configs" for the four standard printer binaries it will never be Open Source.

BR
Anet doesn't even seem to be reading their own forum. Another one.

BR
User avatar
ilros
Posts: 2
Joined: 2021-01-28 9:05

dCrypt wrote: 2021-01-08 7:10 Hi, @AnetLau,

Here viewtopic.php?f=58&t=886 you publish three binaries for ET4,ET4X,ET4PRO/+ corresponding to the Marlin OpenSource code. However, the configs are not published. Why you still publish "closed binaries" from alternative sources?

Unless you share the "configs" for the four standard printer binaries it will never be Open Source.

BR
I think this OpenSource project is tricky - closed binaries. It is not OpenSource it is Free Software.
Post Reply