Motor issues with my A8

For all who are new to 3D Printing, Rapid Prototyping and Additive Fabrication in general
Community rules
1. Be kind and courteous
We're all in this together to create a welcoming environment. Let's treat everyone with respect. Healthy debates are natural, but kindness is required.

2. No hate speech or bullying
Make sure everyone feels safe. Bullying of any kind isn't allowed, and degrading comments about things such as race, religion, culture, sexual orientation, gender or identity will not be tolerated.

3. Only 3D printers advertised.
Only 3D printers or directly related product may be advertised. If you post anything else it will be moderated and you will be banned.

4. Replying to posts
If you reply to a post, make sure your reply is connected with the main topic, do NOT take a topic off track.

5. All post are moderated
Every post on here is moderated - always. Don't bother joining unless you have works to share or problems to inquiry about 3D printers. That is all that will be allowed on this group.
Post Reply
User avatar
Rokaq
Posts: 1
Joined: 2021-02-10 16:01

I'm not exactly new on the entire 3D printing scheme, but some issue has gotten me some consistent headaches during the past 2 weeks, and I simply feel exhausted of searching through forums for anyone with similar issues, so I might as well just make my own post. I just purchased an Anet A8 printer with an Anet v1.5 board, a cheap printer I just wanted to tamper with and have on my desk for minor prints. However, after burning the bootloader, installing Anet 1.0 with Optiboot, dowloading the Anet A8 example config for Marlin 2.0.7.2 and installing the firmware in the board, I went to test all motors individually only to find that they were all sort of messed up in one way or another. Allow me to ellaborate:
  • The X axis motor always starts at -30.00mms, and will never move further to the right than it was when the printer initially booted up. It will also completely ignore the endstops and attempt to move further.
  • Similarly, the Y axis starts at +10.00mms and will also reject going backwards from its position upon turning the printer on. It will also ignore endstops.
  • Moreover, both Z motors won't properly move, instead vibrating in place and making a lot of noise without really going anywhere. Wiring is fine, and they do move as expected upon being connected to the X or Y ports, but won't do so when connected to their own ports. No mechanical issues either, since both rods rotate easily when I do it manually with the printer turned off. This has been a consistent issue ever since I tried the printer for the first time.
  • Finally, the extruder motor won't move, vibrate, hum or even turn on at all. When commanded to move in any direction, it will remain inactive and silent.
I've spent probably dozens of hours setting this printer up, discovering how to properly burn a bootloader and doing all the previous steps, but this just escapes me. If anyone were to offer a solution or a hint as per why this happens, it would be extremely appreciated. Thank you.


Post Reply