New ET5X, level sensor much higher than extruder

Anet 3D printers, add-ons and OEM
Community rules
1. Be kind and courteous
We're all in this together to create a welcoming environment. Let's treat everyone with respect. Healthy debates are natural, but kindness is required.

2. No hate speech or bullying
Make sure everyone feels safe. Bullying of any kind isn't allowed, and degrading comments about things such as race, religion, culture, sexual orientation, gender or identity will not be tolerated.

3. Only 3D printers advertised.
Only 3D printers or directly related product may be advertised. If you post anything else it will be moderated and you will be banned.

4. Replying to posts
If you reply to a post, make sure your reply is connected with the main topic, do NOT take a topic off track.

5. All post are moderated
Every post on here is moderated - always. Don't bother joining unless you have works to share or problems to inquiry about 3D printers. That is all that will be allowed on this group.
Post Reply
User avatar
Posts: 1
Joined: 2020-11-01 14:37

The bottom of the level sensor is about 1cm higher than the bottom of the extruder, making leveling impossible, auto or otherwise. I don't know which one to try to move, and I don't even know if I can move anything that far. Plus, I don't know what the relationship between the bottom of the sensor and the extruder should be. Where can I find out how to deal with this?

Also, the x axis belt has several cm of play in it. Is that okay, or should I find a way to tighten it up so that there is minimal slack?

Post Reply