Brand New ET5X not connecting to pc

Tips & Tricks to tweak your printers, as well as technical help. Topics MUST contain the type of printer you are addressing!
Community rules
1. Be kind and courteous
We're all in this together to create a welcoming environment. Let's treat everyone with respect. Healthy debates are natural, but kindness is required.

2. No hate speech or bullying
Make sure everyone feels safe. Bullying of any kind isn't allowed, and degrading comments about things such as race, religion, culture, sexual orientation, gender or identity will not be tolerated.

3. Only 3D printers advertised.
Only 3D printers or directly related product may be advertised. If you post anything else it will be moderated and you will be banned.

4. Replying to posts
If you reply to a post, make sure your reply is connected with the main topic, do NOT take a topic off track.

5. All post are moderated
Every post on here is moderated - always. Don't bother joining unless you have works to share or problems to inquiry about 3D printers. That is all that will be allowed on this group.
Post Reply
User avatar
Posts: 2
Joined: 2020-11-20 12:43

My Brand New ET5X has turned up today
Ive installed the drivers on windows 10
But Repetier has no control over it. makes out like its connected but no manual control at all or anything else
connected via USB
even if i just save the print to sd card, when it starts the head just goes to the end of the X and then grinds

it would print the prints from the Sd card but nothing else.

All my other printers in the past have worked out the box
Ive set up manual bed leveling done automatic, had messgae from support saying only use Cura, use that works but still will not print from cura sliced G-Code from Micro SD Card, and in the txt from from the micro sd card, it says use Rep host for usb printing lol and that does not work


Post Reply